Chapter 4 Strange Key | The Room 3

Go into the third room. Check out the printing press machine. Try moving the handle. The handle is broken. You will need to fabricate a replacement handle. Take the wooden stick on the sliding panel. Go to the woodworking room.
Ch4 third roomCh4 printing press

Ch4 printing press handle
Go to the saw bench. Place the wooden stick on a holder . Slide the holder towards the blade. Lift the handle to cut the stick. Get a small piece of wood.
Ch4 saw tableCh4 operate saw table

Ch4 get small wood
Go to the mill machine. Insert the small piece of wood. The machine will start operate. Take a lathed piece of wood.
Ch4 mill small woodCh4 fabricate handle

Stop by the main room to check out a mechanical arm next to the forge. Notice a set of strange symbol combination on the arm.
Ch4 mainroom armCh4 combination on wooden arm

Go back to the third room. Insert and turn the lathed piece of wood as the handle. The machine will produce a print of a mechanical arm. Take a look through your eyepiece. Turn the dial to match those on the mechanical arm in the main room. Take the camshaft.
Ch4 repair handleCh4 turn press handle

Ch4 page printedCh4 machine arm print

Ch4 mechanical armCh4 combination on arm

Ch4 camshaft
Go back to the mechanical arm in the main room.

Mechanical Arm Puzzle Solution:
1. Place the camshaft in the arm compartment. The hand is holding a key. There is a dial and a switch. Use the dial near the mechanical arm’s elbow to control the hand. The solution is actually on the print of a mechanical arm from the printing press machine.
Ch4 wooden armCh4 insert camshaft

2. Slide the switch to the second position. Turn the dial until the hand opens. Grab the strange key.
Ch4 arm dial and switchCh4 strange key

Go to the iron box. Look at the top of the box.

Strange Key Puzzle Solution:
1. Check out the side with square bar. Place the key on the bar. Use the key as a handle. Turn the handle until two arrowheads aligned.
Ch4 top iron boxCh4 square bar

2. Check out the side with four spikes. Take a closer look at the strange key. A ring can be rotate on the shaft of the key. Rotate until the square hole align with other three holes. Insert the key on the spikes. Again, use the key as a handle. Turn the handle until two arrowheads aligned on the box.
Ch4 four spikesCh4 key shaft

Ch4 spikes and key
3. Check out the side that has a cylinder with indentation. Take a closer look at the strange key. Rotate the tip of the key so that the bit is pointing up. Insert the key on the cylinder and turn the key so that the arrowheads aligned.
Ch4 indented cylinderCh4 adjust key tip

Ch4 turn indented cylinder
A mechanism will trigger and reveal an engraved pyramid. Take the pyramid. You will be teleported back to the glass room.
Ch4 pyramid


Comments

Chapter 4 Strange Key | The Room 3 — 1 Comment

Leave a Reply

Your email address will not be published. Required fields are marked *